Ergotron AnthroBench 293 Series Assembly Instructions

AnthroBench Leg Extensions
Assembly Instructions
This instruction is for the 293xx and 295xx.
Before beginning assembly, review the parts listed below to verify that your shipment is complete. Items shown in
gray are not included with this accessory.
Review all instructions for your assembly before you start.
SAVE THESE INSTRUCTIONS!

Enclosed Parts List

01– Leg Extension ............................Qty. 2.....................(see below)
24" Leg Extension (293xx) ................................... 625-5527-xx
36" Leg Extension (295xx) ...... ............................ 625-5528-xx
02– Base Tube Screws .................. Qty. 4.................. 325-5000-00
03– Bench Extension Caps .......... Qty. 2...................225-5376-xx
04– Keps Nuts .................... Qty. 4.................. 325-5130-03
( 1 / -20)
4
05– 1/2" Button Head Screw ..........Qty. 4.................. 325-5003-00
• 09/18
300-5002-00 rev. H
05
04
01
02
03
Fastener quantities listed are the minimum needed for
your assembly. Your shipment may contain a few extras.
A 5 / " Anthro Hex Driver, 1 /
32 4
(not included) will be needed for this assembly.
Built with Anthro-DNA™
" Hex Key & 3-Way Wrench