Morsø P30/31
Before you start using your new Morsø pellet stove, make sure that the stove
has been installed according to the local regulations.
The installation must be approved by an authorized chimney sweeper.
1.
Place the supplied baffle in the stove. (see backside)
2.
Before the initial ignition, fill up the pellet storage magazine including
a handful of pellets in the fire pot – Only use 6 mm pellets.
3.
Switch on the stove, pressing button No. 3 until the display shows start.
The stove will automatically ignite. Wait until the stove, after approx. 10
min., switch to running mode.
4.
Adjust to the wanted temperature using button No. 4 and 5. The
temperature can be set to between 7°and 40°.
5.
Set to program Power 1,2,3,4 or 5 with button 1-2.
IMPORTANT – newer set the power level higher than necessary, to reach the
wanted temperature. That will result in unnecessary noise from the stove.
Then you have both the time and warmth to read the manual carefully.
It is very important to learn all the different functions of the stove including
Quick start guide
You have now started:
the safety precautions.
Morsø Jernstøberi A/S - 13.08.2014 - 72301900
Need help?
Do you have a question about the P31 and is the answer not in the manual?
Questions and answers