System - NEC MultiSync UN552 User Manual

OPTION
OPTION MENU
OPTION POWER
AUDIO *1
INTERNAL PC *1
OFF WARNING
AUTO OFF
START UP PC
FORCE QUIT
SLOT2 CH SETTING
AUTO
CH1
CH2
SLOT2 CH SELECT
DisplayPort
TMDS
RESET
* : This function depends on which Option Board installed in the monitor. When changing the setting, turn the monitor's main power switch off and on again.
1

SYSTEM

SYSTEM MENU
MONITOR INFORMATION
FIRMWARE
MAC ADDRESS
FACTORY RESET
Allows the monitor to supply power to an Option Board slot during power save mode or standby mode.
[AUTO]: Power supply depends on whether or not an Option Board is connected.
[ON]: Power is continuously supplied to the Option Board slot, even during power save and standby modes.
[OFF]: Power to the Option Board slot stops during power save and standby modes.
NOTE: To activate the power management function with no signal input from a connected slot 2 type Option
Board, please set [OPTION POWER] to [AUTO] or [ON].
Selects the sound input signal according to the slot2 type option specifications. To activate [DIGITAL], select
[OPTION] for input signal and [OPTION] for [AUDIO INPUT].
NOTE: [DIGITAL] is activated only when [OPTION] is selected for input signal and [OPTION] for [AUDIO
INPUT].
The function is available for a slot 2 type PC.
Shows a warning, when shutting down the power to the internal PC, that the PC should be turned off from
within the OS of the PC. This message cannot be changed.
This function is available when [OPTION POWER] is [OFF].
When [ON] is selected, the monitor automatically powers off when the internal PC is turned [OFF].
NOTE: If you select [OFF], the monitor power is not automatically [ON] when the internal PC is [ON].
When [YES] is selected, the internal PC will start.
When [YES] is selected, a forced shutdown of the internal PC will be carried out.
Please use this function only when the operating system cannot be shut down manually.
Selects signal type according to the slot 2 type option specifications.
Sets the signal type automatically.
Fills the screen entirely with the signal which is selected in [SLOT2 CH SELECT].
The DisplayPort signal is displayed on the left half of the screen, the TMDS signal is displayed on the right
half. If the internal PC does not support either one of the signal types, the existing signal will automatically be
displayed on the full screen.
This function is available only when [SLOT2 CH SETTING] is [CH1].
Shows the DisplayPort signal from a slot 2 type PC option on the full screen.
Shows the [TMDS] signal from a slot 2 type PC option on the full screen.
Resets the [AUDIO] setting back to the factory setting within the OPTION menu.
Shows the model name, serial number and firmware version of the monitor.
[CARBON SAVINGS]: Display the estimated carbon saving information in kg-CO2. The carbon footprint factor
in the carbon saving calculation is based on the OECD (2008 Edition).
[CARBON USAGE]: Display the estimated carbon usage information in kg-CO2. This is the arithmetic
estimation, not actual measurement value. This estimation is based without any options.
Shows the monitor's current firmware version.
Shows the monitor's [MAC ADDRESS].
All items are returned to factory shipment state.
NOTE: This will reset all items in all daisy chained monitors. Please be careful to avoid resetting all items
inadvertently.
English−122