Power On And Off Modes - NEC MultiSync UN552 User Manual

Large format display
Hide thumbs Also See for MultiSync UN552:
Table of Contents

Advertisement

Power ON and OFF Modes

Press the
button on the Control Panel or POWER ON button on the Remote Control to turn on the monitor.
The monitor's power LED indicates the current status of the monitor. Please refer to the following table for information about the
LED indicator.
LED indicator status and
lighting pattern
Glowing blue
Blinking green*
1
Glowing amber
Blinking amber
Glowing red
*
: Time setting for [AUTO POWER SAVE] is available at [POWER SAVE] (See
1

NOTEN:
• The blue LED indicator that the monitor is powered on and functioning normally can be turned off in the monitor's
OSD menu options. See
 • If the indicator is blinking red in a combination of long and short durations, a certain failure might have occurred,
please contact your supplier.
The Main Power switch must be in the ON position in order to power up the monitor using the POWER ON button on the remote
control or the
button on the Control Panel.
OFF
Main Power Switch
Normal
Under any of the conditions below, no input signal has
been detected by the monitor during the period of time you
set:
The monitor is using an Option Board.
[INPUT DETECT] is set to a setting except for [NONE].
[USB POWER] is set to [ON].
DisplayPort in the [TERMINAL SETTINGS] is set to
[MST].
No AV signal input has been detected by the monitor during
the period of time you set. (with network signal input)
No AV signal input has been detected by the monitor during
the period of time you set. (no network signal input)
Turn off the monitor by the remote control or the monitor
button.
page
120.
ON
Condition
page
116).
English−32
Recovery
1. Turn on the monitor by the remote
control or the monitor button.
2. Send an AV signal input to the
monitor.
Turn on the monitor by the remote
control or the monitor button.
Button

Advertisement

Table of Contents
loading

This manual is also suitable for:

Multisync un552v

Table of Contents