Installing The Rfid Option - Lexmark CS725R Integration Manual

Installing the RFID Solution

Installing the RFID option

CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock, if you are accessing the controller
board or installing optional hardware or memory devices sometime after setting up the printer, then turn
off the printer, and unplug the power cord from the electrical outlet before continuing. If you have any
other devices attached to the printer, then turn them off, and unplug any cables going into the printer.
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet, and then from the printer.
3
Unpack the RFID option, and then remove all packing material.
4
Align the RFID option above the media tray, and then lower the RFID option until it clicks into place.
5
Lift the printer using the side and rear handles.
CAUTION—POTENTIAL INJURY: If the printer weight is greater than 20 kg (44 lb), then it may
require two or more people to lift it safely.
Note: If an optional 550‑sheet tray is installed, then unlock it before lifting the printer. Do not try to lift the
printer and the optional tray at the same time.
9