5
TONE SQUELCH AND POCKET BEEP
NOTE: CB channels 5 and 35 are for only emergency use. The Tone Squelch or Pocket
Beep function is not selectable on these channels.
■ Tone Squelch
The transceiver is equipped with 51 CTCSS tone frequencies and 104 DTCS codes.
The CTCSS/DTCS operation enables you to communicate in the silent standby mode
because you will only receive calls from group members using the same CTCSS tone
frequency or DTCS code.
D Setting CTCSS tone frequency or DTCS
code
1.
Open the "CTCSS/DTCS" screen.
[MENU] > Settings > CTCSS/DTCS
2.
Select "CTCSS" or "DTCS," and then push [►] or
[ENT].
3.
Push [▲] or [▼] to set a CTCSS tone frequency or
DTCS code, and then push [ENT] to set it.
• When the Tone Squelch or Pocket Beep function is
turned ON, the selected CTCSS tone frequency or DTCS
code is displayed on the operating screen.
L Push [CLEAR] to return to the previous screen.
NOTE:
• The selectable CTCSS tone frequencies and DTCS
codes are listed on the next page.
• The transceiver has 51 tone frequencies so their spacing
is narrow, compared to units having 38 tones. Therefore,
some tone frequencies may receive interference from
adjacent tone frequencies.
• If the transceiver receives a signal with no code or a
code that is different from the code set in the transceiver,
the TX/RX indicator lights green, but the received signal
is not output from the speaker.
16
The "CTCSS" screen
The "DTCS" screen
CTCSS tone frequency
CTCSS tone frequency
DTCS code
DTCS code