Fuse Replacement; Installation - Icom IC-455 Instruction Manual

9
CONNECTIONS AND INSTALLATION

■ Fuse replacement

If the fuse blows or the transceiver stops functioning, find the source of the problem,
repair it, and replace the damaged fuse with a new one of the proper rating. (FGB 5 A)

■ Installation

D Main unit
Select a location that can support the weight of the transceiver and does not interfere with
driving. Contact your car dealer or Icom dealer for advice for installing in a vehicle.
R DANGER! NEVER place the transceiver where air bag deployment may be
obstructed during mobile operations.
R WARNING! NEVER place the transceiver where the vehicle's normal operation may
be hindered or where it could cause bodily injury.
CAUTION: DO NOT install or place the transceiver in a place without adequate
ventilation or block any cooling vents on the bottom of the transceiver. Heat dissipation
may be reduced and damage the transceiver.
DO NOT place the transceiver where hot or cold air blows directly onto it, during mobile
operation.
NOTE: DO NOT use or leave the transceiver in areas with temperatures below –10°C
or above +60°C, or in areas subject to direct sunlight, such as the dashboard.
Installation example:
The transceiver is installed on the centre console.
34
5 A fuse
Main unit
Microphone