Sfp/Sfp+ Transceivers - Siemens SIMATIC NET SCALANCE W786 Series Operating Instructions Manual

Connecting up

6.7 SFP/SFP+ transceivers

Device variant W786-x RJ-45
Follow the steps below to connect an Ethernet cable to a SCALANCE W786 with an RJ-45 jack:
1. Insert the RJ-45 plug of the Ethernet cable in the jack of the SCALANCE W786-x RJ-45.
2. Secure the Ethernet cable with a strain relief clamp.
Note
Keep the dummy plugs
Keep any dummy plugs taken out of the slots for later use.
See also
Cables for power supply and Ethernet (Page 53)
6.7 SFP/SFP+ transceivers
Approved plug-in transceivers for SCALANCE W786-2 SFP
SFP/SFP+ plug-in transceivers allow the SCALANCE W786-2 SFP device to be equipped with
interfaces for fiber-optic cables. There are SFPs for different cable materials (multimode, single
mode) and cable lengths. The following table lists the models approved for SCALANCE W786-2
SFP.
Transceiver
SFP992-1
SFP992-1LD
SFP992-1LH
SFP992-1LH+
SFP992-1ELH
62
Properties
1 x 1000 Mbps, LC port optical, multimode
glass, up to max. 750 m
1 x 1000 Mbps, LC port optical, single mode
glass, up to max. 10 km
1 x 1000 Mbps, LC port optical, single mode
glass, up to max. 40 km
1 x 1000 Mbps, LC port optical, single mode
glass, up to max. 70 km
1 x 1000 Mbps, LC port optical, single mode
glass, up to max. 120 km
Article number
6GK5992-1AL00-8AA0
6GK5992-1AM00-8AA0
6GK5992-1AN00-8AA0
6GK5992-1AP00-8AA0
6GK5992-1AQ00-8AA0
Operating Instructions, 12/2021, A5E03678337-14
SCALANCE W786-x