Mounting Device On The Mounting Plate - Siemens SIMATIC NET SCALANCE W786 Series Operating Instructions Manual

Installation and removal
5.5 Mounting with mounting plate
5.5.6

Mounting device on the mounting plate

Procedure for mounting the device
B
Figure 5-12
Follow the steps below to fit a SCALANCE W786 to a mounting plate:
1. Lead the cables into the housing of the SCALANCE W786 (position A in the figure above).
Note the information in the section "Connecting up cables".
2. Fit the SCALANCE W786 so that the upper edge of the rear of the housing is below the two
catches of the mounting plate (position B in the figure above).
44
1
C
2
Fitting the SCALANCE W786 to a mounting plate
A
Operating Instructions, 12/2021, A5E03678337-14
SCALANCE W786-x