Mounting The Device With Mounting Clamps - Siemens SIMATIC IFP1500 Operating Instructions Manual
Industrial monitors
Hide thumbs
Also See for SIMATIC IFP1500:
- Operating instructions manual (104 pages) ,
- Quick start manual (2 pages) ,
- Operating instructions manual (130 pages)
Table of Contents
Advertisement
3.2.3
Mounting the device with mounting clamps
Requirement
● All packaging components and protective films have been removed from the device.
● The mounting clamps included in the accessory kit are ready to hand.
Procedure
Note
If the mounting seal is damaged or protrudes over the device, the degree of protection is not
guaranteed.
Industrial Flat Panel IFP1500, IFP1900, IFP2200
Operating Instructions, 09/2012, A5E31298376-AA
Installing and connecting the device
3.2 Mounting the device
Proceed as follows:
1. Working from the front, insert
the device into the mounting
cut-out.
2. Insert the mounting clamp
into the recesses on the
device. Make sure they are in
the correct position, see
chapter Position of the
mounting clamps or latch
fasteners (Page 32).
3. Tighten the mounting clamp
with a screwdriver. The
maximum permitted torque is
0.5 Nm.
4. Repeat steps 2 and 3 for all
mounting clamps.
5. Check the fit of the mounting
seal.
33
Advertisement
Table of Contents
