Table of Contents
Advertisement
Chapter 3: Basic System Operations
Adding or Removing File Systems After Initial Configuration
Adding or Removing File Systems After Initial
Configuration
40
If you need to add or remove file systems after the initial configuration
of your StorNext G300 Gateway Appliance, a wizard in the Service
Menu will step you through the process.
To add or remove a file system after initial configuration:
1 Add a new file system in StorNext. Refer to the "The StorNext
Configuration Wizard" section in the latest version of the
User's Guide
for instructions on configuring your file system.
2 Open a putty or secure ssh connection to the StorNext G300
Gateway Appliance via the IP address of the LAN client interface.
3 Log on using the "install" credentials and the password "password".
You will automatically be taken to the install wizard for
configuration.
4 From the Service Menu, type 0 to invoke the Install Wizard. The
Install Wizard Menu displays.
5 Select 1 for the Advanced Settings option. The Advanced Settings
Menu displays.
*** Advanced Settings Menu ***
0) Update Filesystem list
1) Configure fsports settings
2) Update MDC and nameservers
3) Update GW Client interface list - Update the Gateway client
4) Update Gateway software
5) Change user password
6) Set Date/Time
7) Advanced Network Setup
8) Display Configuration Settings
9) Activate StorNext Settings
6 Select 0 for the Update Filesystem list option. The Select
Filesystems to be Mounted Menu displays.
- Update list of filesystems
exported by the gateway.
- Constrain the StorNext TCP and
UDP port usage.
- Update the MDC IPs and FS
nameserver IPs.
interface list.
>>- Upgrade the StorNext Gateway
software version on the gateway.
- Sets the password for the
stornext and install users.
- Sets date and time of the system.
>>>- Allows advanced configuration of
network ports.
- Display configuration
settings.
- Apply all StorNext settings
StorNext G300 Gateway Appliance Hardware Guide
StorNext
Advertisement
Table of Contents
