Table of Contents
Advertisement
3. Connecting your aerial and satellite
Connecting a VCR to the TV
Scart lead
(not supplied)
4. Switching on the TV
1. Connect your existing aerial to the socket
marked
on the rear of the TV as shown.
2. Connect your satellite dish to the F-type socket
marked
.
1. Connect your satellite dish to the F-type
socket marked
on the rear of the TV as
shown.
2. Connect your existing aerial to the RF IN
socket on your VCR.
3. Connect a lead from the RF output of your
VCR to the analogue socket marked
connect a scart lead as shown.
4. Connect the VCR to the mains socket and
switch on.
5. Insert a pre-recorded tape into the VCR and
press the 'PLAY' button. This enables the TV
to locate and store the video channel during
the 'Automatically tuning the TV' procedure.
1. Connect the TV plug to your mains socket
(220 - 240 V AC, 50 Hz).
2. Press the on/off switch in a forward direction
to switch on the TV.
Note: If the red indicator on the front of the TV is lit the
TV is in standby mode. Press the TV
on the remote control to switch on the TV. Please
be patient as the picture may take a few moments
to appear on screen.
Getting started
then
/
button
5
Advertisement
Table of Contents
