Connecting An Aerial And Vcr; Switching On The Tv; Getting Started - Sony KV-32FQ80K Operating Instructions Manual

32FQ80 B5 Part 2.fm Page 5 Wednesday, May 29, 2002 9:51 AM
3

Connecting an aerial and VCR

Connecting an aerial only
4 s 4
(SMARTLINK)
3 s 3
VCR
2
DVD
1
ANALOGUE
R/D/D/D L/G/S/I
D
DOLBY. THE DOUBLE-D SYMBOL D
ARE TRADEMARKS OF DOLBY
LABORATORIES
Connecting an aerial and VCR
4 s 4
(SMARTLINK)
3 s 3
VCR
2
DVD
1
ANALOGUE
R/D/D/D L/G/S/I
DOLBY. THE DOUBLE-D SYMBOL D D
ARE TRADEMARKS OF DOLBY
LABORATORIES
Scart lead
(not supplied)
VCR
4

Switching on the TV

1.
1.
2.
3.
RF lead
(not supplied)
1.
2.
Connect your aerial lead to the aerial socket
labelled on the rear of the TV.
Connect your aerial lead to the IN* socket on
your VCR.
Connect an RF lead from the OUT* socket on
your VCR to the aerial socket labelled
the rear of the TV.
Connect a fully wired 21-pin scart lead from the
scart socket marked
3/ s 3
TV to a scart socket on your VCR**
Notes: *Socket names may vary depending on
make and model of VCR. Refer to your VCR
instruction manual for details.
**If your VCR does not have a scart socket
follow the connecting instructions above
ignoring the scart lead connection.
You will also need to manually tune the VCR
to a spare TV channel (ideally channel 0,
refer to the 'Manual Programme Preset
menu' section of this instruction manual).
Connect the TV plug to your mains socket
(220 - 240V AC, 50 Hz).
The TV is usually switched on. If not, push in
the On/Off button on the front of the TV.
If the red standby mode indicator on the front of
/
the TV is lit, press the TV
remote control to switch on the TV set. Please
be patient as the picture may take a few
moments to appear on the TV screen.

Getting Started 5

on
on the rear of the
button on the