Table of Contents
Advertisement
en Troubleshooting
Fault
Water is left in the appliance
at the end of the pro-
gramme.
Appliance cannot be
switched on or operated.
Appliance does not start.
Programme starts automat-
ically.
Appliance stops during the
programme or cuts out.
58
Cause
Software update is taking
place.
Appliance functions have
failed.
The mains fuse has tripped.
Mains cable is not inserted.
Appliance door is not closed
properly.
You did not wait until pro-
gramme ended.
Appliance door is not closed
properly.
Power and/or water supply
has been interrupted.
Top basket is pressing
against inner door and pre-
venting appliance door from
being closed securely.
Troubleshooting
→ "Terminate programme",
▶
Page 36
Wait until the software update has
▶
finished.
Pull out the mains plug or switch off
1.
the fuse.
Wait at least 2 minutes.
2.
Connect the appliance to the power
3.
supply.
Switch the appliance on.
4.
Check the relevant fuse.
▶
Check whether the socket works.
1.
Check whether the mains cable is
2.
properly inserted in the socket and
on the rear of the appliance.
Close the appliance door.
▶
→ "Terminate programme",
▶
Page 36
Close the appliance door.
▶
Check the power supply.
1.
Check the water supply.
2.
Check whether the rear panel of the
▶
appliance is being pressed in by a
socket or hose holder that has not
been removed.
Arrange the tableware so that no
▶
parts project beyond the basket
and prevent the appliance door
from closing properly.
Advertisement
Table of Contents
