Table of Contents
Advertisement
en Troubleshooting
Fault
Appliance interior still wet
after wash cycle.
Remnants of food on table-
ware.
52
Cause
Not a fault. The condensa-
tion drying principle causes
water droplets in the tub –
they are indeed desirable
here. The moisture in the air
condenses on the inside
walls, runs off and is
pumped out.
Tableware is placed too
close together or basket is
overfilled.
Spray arm rotation is
blocked.
Spray arm nozzles are
blocked.
Filters are soiled.
Filters are inserted incor-
rectly and/or not engaged.
Washing programme selec-
ted too weak.
Tableware has been pre-
cleaned too intensely. The
sensors chose a weaker pro-
gramme. Stubborn soiling
cannot be entirely removed.
Tall narrow receptacles in
corner areas are not rinsed
adequately.
Top baskets on right and left
are not set to same height.
Troubleshooting
No action required.
Arrange tableware with sufficient
1.
space in between.
The spray jets must reach the sur-
faces of the tableware.
Avoid points of contact.
2.
Arrange tableware so that it does
▶
not obstruct spray arm rotation.
Clean the "Spray arms" → Page 44.
▶
Clean the filters.
▶
→ "Cleaning filters", Page 43
Insert the filters properly.
1.
→ "Filter system", Page 43
Engage the filters.
2.
Select a more intensive washing
▶
programme.
→ "Programmes", Page 19
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 12
Only remove large remnants of food
▶
and do not prerinse tableware.
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 12
Do not position tall narrow recept-
▶
acles at too great an angle or in
corner areas.
Set the top baskets on the left and
▶
right to the same level.
Advertisement
Table of Contents
