Auto-Tuning The Tv - Sony Bravia KDL-40W2000 Operating Instructions Manual

7: Auto-tuning the TV

The TV will now search for and store all available TV
channels.
1
Before you start auto-tuning the TV, insert
a pre-recorded tape into the VCR
connected to the TV (page 6) and start play
back.
The video channel will be located and stored on
the TV during auto-tuning.
If no VCR is connected to the TV, this procedure
is not required. Go to step 2.
2
Press G/g to select "OK", then press
The TV starts searching for all available digital
channels, followed by all available analogue
channels. This may take some time, please be
patient and do not press any buttons on the TV or
remote.
If a message appears for you to confirm the aerial
connections
No digital or analogue channels were found.
Check all the aerial connections and press
start auto-tuning again.
3
When the Programme Sorting menu
appears on the screen, follow the steps of
"Programme Sorting" (page 32).
If you do not change the order in which the
analogue channels are stored on the TV, go to step
4.
8
GB
2
4
.
to
4
Press MENU to exit.
The TV has now tuned in all the available
channels.
Note
When a digital broadcast channel cannot be received, or
when selecting a region in which there are no digital
broadcasts in step 4 under "6: Selecting the language and
country/region", the time must be set from "Clock Set" in the
"Set-up" menu (page 29) after performing step 4.