Annunciations; Error With A Summary Alarm; Alarm Summary Event - Siemens SIPROTEC 7SJ61 Manual

Notes to SIPROTEC objects
1.1

Annunciations

1.1.1

Error with a summary alarm

Reference
1.1.2

Alarm Summary Event

"Reference
12
Note
The description of the standard mappings contains the pre-allocation of the mapping
files at delivery or first assignment of a mapping in DIGSI 4 to the SIPROTEC device.
Changes of the allocation and the scaling of the measured values are possible in ad-
aptation to the concrete installation enviroment (ref. to page 3).
Note
Depending on the device composition and the existing protection packages not all of
the indicated binary inputs or protection annunciations (and corresponding IEC
60870-5-103 Information numbers) may be available in the SIPROTEC device
The "Error with a summary alarm" (Obj.- Adr. 140) is ON if at least one of the following
internal alarms assumes the value ON:
• "Error 5V", "Error 0V", "Error -5V", "Failure Battery empty", "Error Power Supply"
• "Error I/O Board", "Error Board 1", "Error Board 2", "Error Board 3", "Error Board 4",
"Error Board 5", "Error Board 6", "Error Board 7"
• "Error Offset", "Calibration data fault"
ref to chap. 3.2.8
The "Alarm summary event" (Obj.- Adr. 160) is indicated, if at least one of the following
internal alarms assumes the ON status:
• "Failure Current Balance", "Failure Current Summation", "Voltage Balance"
• "Failure Phase Sequence Current", "Failure Phase Sequence Voltage",
• "Failure RTD-Box 1", "Failure RTD-Box 2".
ret. to chap. 3.2.8
7SJ61 / 7SJ62 / 7SJ64 Bus mapping
C53000-L2540-A306-2