Troubleshooting - ProFusion PH-960XNR Owner's Manual

TROUBLESHOOTING

If your heater fails to operate, please follow these procedures:
This heater is intended to be a ceiling-mounted heater. It has a
thermal cut-off protection. If the thermal cut-off protection trips, then,
switch off the power. Switch off the circuit breaker.The unit
should reset automatically after 10 minutes. If the thermal cut-off
protection trips again, consult a certified electrician to determine the
reason for overheating.
Problem
Overheat protection has
temporarily deactivated the
heater.
Room temperature has been
Unit is
warmed up to thermostat
not
setting.
heating.
Breaker/Fuse has been
tripped.
Check & ensure there are no
combustible materials within
0.9 meters (3 feet)
surrounding the heater.
The A drop of oil fell on the
heater is heating coil during the
producing manufacturing process. It will
a burning quickly evaporate and should
smell. not occur again.
Ensure a minimum clearance
of 36 inches (90 cm) from
both sides and rear of heater
to adjacent walls.
Probable Cause
Turn the heater OFF; Switch
off the circuit breaker. Wait
10 minutes before turning on
the heater
To increase the room
temperature, adjust thermostat
control knob to a higher setting
Check your electrical box to
confirm the breaker has not
been blown. This may occur if
the receptacle is shared
between other high
consumption appliances.
Remove any combustible
items from the heater.
Ensure room in which heater
is situated is well ventilated.
Reposition the heater so there
is enough space around the
heater to the adjacent walls.
13
Solution