Scott 230607 User Manual page 4

Figure 1 Figure 2
2. In order to attach the Shield lens to the helmet, align the three attach-
ment clips with the three helmet attachment points and press firmly to
connect all three (figure 3). Before use pull gently downwards on the lens
to ensure all three attachment clips are securely connected to the helmet.
Figure 3 Figure 4
3. To remove the lens pull firmly on the side of the lens (see figure 4) to
unclick all three connections.
STORAGE
To prevent the lenses from being scratched, it is best to store the sun-
glasses only in the case designed for them. The sunglasses may not be
stored in direct sunlight or in locations where the temperature exceeds
50° C (122°).
CLEANING
Be careful when cleaning your sunglasses! Remove any dirt by blowing
softly on them. Polish the lenses with a soft cotton cloth or a special lens
cloth. Do not use paper towels or other materials containing wood fiber
or any other cleaning material.
INSPECTION
Inspect your glasses prior to use for possible damage. If the lenses show
scratches or other blemishes, they should be repaired or replaced; oth-
erwise sufficient protection from harmful UVA and UVB rays cannot be
guaranteed.
Responsible for the development and commercialization in the EC and
worldwide is : SCOTT Sports SA, Route du Crochet 17, CH-1762 Givisiez
Distribution USA : SCOTT USA Inc., 651 West Critchlow Drive, Ogden, UT
84404, USA
Distribution other countries : SSG (Europe) Distribution Center SA, P.E.D
Zone C1, Rue du Kiell 60, 6790 Aubange, Belgium.
WWW.SCOTT-SPORTS.COM
©SCOTT SPORTS SA 2016. All rights reserved. Rev. 01 of 01.2016. The information
contained in this manual is in various languages but only the English version will be
relevant in case of conflict.