SAES SIP POWER User Manual page 47

10.1. Payload for 0x40 – Set Working Parameters Command
0 16bits 15 16
VOUT_SETPOINT VOUT_RAMP_INTV
120 32bits 151 152
SW2_THR_MAX
264 8bits 271
MODBUS_ID

Bit 0:15 – Output voltage set-point
This field contains output voltage set point in V units. The minimum allowed value is 1000V, the
maximum allowed value is 6000V.

Bit 16:47 – Output voltage ramping interval
This field contains output voltage ramping interval in ms units. The minimum allowed value is
1000ms, the maximum allowed value is 60000ms.

Bit 48:55 – Switches modes
This byte is structured as follows
• Bit 5:4 – SW3 Mode
This field contains switch SW3 mode. Allowed modes are:
• 0 – SW3 switch is bypassed (OFF)
• 1 – SW3 switch is in simple mode (SIMPLE)
• 2 – SW3 switch is in window mode (WINDOW)
• Bit 3:2 – SW2 Mode
This field contains switch SW2 mode. Allowed modes are:
• 0 – SW2 switch is bypassed (OFF)
• 1 – SW2 switch is in simple mode (SIMPLE)
• 2 – SW2 switch is in window mode (WINDOW)
• Bit 1:0 – SW1 Mode
This field contains switch SW1 mode. Allowed modes are:
• 0 – SW2 switch is bypassed (OFF)
• 1 – SW2 switch is in simple mode (SIMPLE)

Bit 56:87 – Switch SW1 threshold
This field contains switch SW1 threshold in nA units.

Bit 88:119 – Switch SW2 low threshold
This field contains switch SW2 low threshold in nA units. This is also SW2 threshold in SIMPLE
mode.

Bit 120:151 – Switch SW2 high threshold
This field contains switch SW2 high threshold in nA units.

Bit 152:183 – Switch SW3 low threshold
This field contains switch SW3 low threshold in nA units. This is also SW3 threshold in SIMPLE
mode.
M.HIST.0109.23 Rev.1
32bits 47 48
32bits 183 184
SW3_THR_MIN SW3_THR_MAX
USER MANUAL - SIP POWER ION PUMP CONTROLLER
8bits 55 56
SW_MODE SW1_THR
32bits 215 216
KEEPALIVE
32bits 87 88 32bits
SW2_THR_MIN
32bits 247 248 16bits
CONV_RATE
Page 47 of 62
119
263