SAES SIP POWER User Manual page 21


A / V / W key can select among current / voltage / power values

Torr / Pa / mb key converts the pressure unit of measurement to Torr / Pascal / mbar;
moreover pressing this latter key for a long period deletes all the notifications on display.
SETTING page
The functions of each key are shown above and below them.
 To enter and exit SETTING menu press at the same time central and right keys for 5 seconds
 Use the keys
or
 To modify a parameter press ENTER; a blinking cursor will indicate the parameter change
mode. In order to modify the parameter act on keys
A short pressure increments/decrements the value by 1 unit, a long pressure will make the
values change quickly, the longer the pressure, the faster the change.
Press ENTER to save and make a value active.
For multifield parameters ENTER will switch from one field to the next and saving will only
happen when all field will be modified.
 In order to leave SETTING menu, press at the same time central and right keys for 5 seconds
For details on all setting see SETTINGS chapter.
M.HIST.0109.23 Rev.1
to run through the menu
USER MANUAL - SIP POWER ION PUMP CONTROLLER
or .
Page 21 of 62