At+Qgpsloc Obtain Fixed Position - Quectel UC20 GNSS At Command Manual

Parameter
<errcode> Integer type, indicate the error code of the operation. If it is not 0, it is the type of error
(Please refer to the chapter

2.5. AT+QGPSLOC Obtain Fixed Position

Before using this command, GNSS engine must be turned on by AT+QGPS. If it does not fix position
successfully, +CME ERROR: <errcode> will be returned to indicate the corresponding situation. Note:
command's response appears on current AT port.
AT+QGPSLOC Obtain Fixed Position
Test Command
AT+QGPSLOC=?
Read Command
AT+QGPSLOC?
Reference
Parameter
<UTC> UTC time. Format: hhmmss.sss (quoted from GPGGA sentence).
<latitude> Latitude. Format: ddmm.mmmm N/S (quoted from GPGGA sentence).
dd
mm.mmmm
N/S
<longitude> Longitude. Format: dddmm.mmmm E/W (quoted from GPGGA sentence).
ddd
mm.mmmm
E/W
<hdop> Horizontal precision, 0.5-99.9 (quoted from GPGGA sentence).
<altitude> The altitude of the antenna away from the sea level(unit: m), accurate to one decimal
UC20_GNSS_AT_Commands_Manual
5 ).
X X
Response
+QGPSLOC:
<UTC>,<latitude>,<longitude>,<hdop>,<altitude>,<fix>,<c
og>,<spkm>,<spkn>,<date>,<nsat>
OK
Response
+QGPSLOC:
<UTC>,<latitude>,<longitude>,<hdop>,<altitude>,<fix>,<c
og>,<spkm>,<spkn>,<date>,<nsat>
OK
or
+CME ERROR: <errcode>
00-89 (degree).
00.0000-59.9999 (minute).
North latitude/ South latitude.
000-179 (degree).
00.0000-59.9999 (minute).
East longitude/West longitude.
Confidential / Released
UC20 GNSS AT Commands Manual
WCDMA Module
14 / 25