Parameter
<gnssstate>
<gnssmode>
<fixmaxtime>
<fixmaxdist>
<fixcount>
<fixrate>
<errcode>
2.4. AT+QGPSEND Terminate GNSS Session
Turn on GNSS engine by AT+QGPS, when <fixcount> is 0, GNSS engine will position continuously, you
can force to terminate it by AT+QGPSEND.
reach the specified value, it will terminate automatically.
AT+QGPSEND
Test Command
AT+QGPSEND=?
Read command
AT+QGPSEND?
Execution Command, terminate GNSS
session
AT+QGPSEND
Reference
UC20_GNSS_AT_Commands_Manual
GNSS state.
0
GNSS off.
1
GNSS on.
GNSS start mode.
1
Standalone.
The max positioning time, unit: s, indicates the response time during the
measurement of the GNSS pseudo range, the upper time limit of the GNSS
satellite searching, include the time for demodulating the ephemeris data and
calculating the position.
1-30-255
Max positioning time.
Accuracy threshold of positioning, unit: m.
0-50-1000.
Positioning times.
0–1000
Positioning time. 0 indicates continuous position. Non 0 indicates the
actual positioning times.
The intervals between the first and second positioning, unit: s.
1–65535.
Integer type, indicates the error code of the operation. If it is not 0, it is the type of
error (Please refer to the chapter
When
Terminate GNSS Session
Response
OK
Response
OK
Response
OK
or
+CME ERROR: <errcode>
UC20 GNSS AT Commands Manual
5
).
X
X
<fixcount> is not 0, and the actual positioning times
Confidential / Released
WCDMA Module
13 / 25