At+Qgpsxtratime Inject Gpsonextra Time - Quectel UC20 GNSS At Command Manual

AT+QGPSXTRA
Test Command
AT+QGPSXTRA=?
Read Command
AT+QGPSXTRA?
Write Command
AT+QGPSXTRA=<xtraenable>
Reference
Parameter
<xtraenable> Enable gpsOneXTRA functionality, the setting will be auto saved to NVRAM.
0
1
<errcode> Integer type, indicate the error code of the operation. If it is not 0, it is the type of error
(Please refer to the chapter

2.8. AT+QGPSXTRATIME Inject gpsOneXTRA Time

This command can be used to inject time to GNSS engine. Before using it, you must turn off the GNSS
engine and configure <xtraenable> by AT+QGPSXTRA. After activating gpsOneXTRA functionality,
GNSS engine will ask for gpsOneXTRA time and gpsOneXTRA data. Meanwhile, before injecting
gpsOneXTRA data, gpsOneXTRA time must be injected first by this command.
AT+QGPSXTRATIME
Test Command
AT+QGPSXTRATIME=?
Read Command
AT+QGPSXTRATIME?
UC20_GNSS_AT_Commands_Manual
Enable gpsOneXTRA Functionality
Response
+QGPSXTRA: (0,1)
OK
Response
+QGPSXTRA: <xtraenable>
OK
Response
OK
or
+CME ERROR: <errcode>
Disable gpsOneXTRA.
Enable gpsOneXTRA,restarting UC20 take effect.
5).
X
Inject gpsOneXTRA Time
Response
+QGPSXTRATIME: 0,<xtratime>,(0,1),(0,1),<uncrtn>
OK
Response
OK
UC20 GNSS AT Commands Manual
Confidential / Released
WCDMA Module
17 / 25