Table of Contents
Advertisement
INSTALLATION
Reversing the door
The cabinet is supplied from the factory right-hung. The door can subsequently be
rehung on the opposite side. A rehanging set is required to rehang the door. This
can be ordered as a spare part.
Rehanging set
Connector for cables.
■
New cable with plastic bushing.
■
Upper hinge, 1 right and 1 left.
■
1
Undo the cabinet from the wall
and turn it so that you can access
the rear.
2
Undo the three screws (1) holding
the cover in place as per the
picture and remove the cover.
3
Carefully place the cabinet on its
back.
4
Remove the cover (2) for the
upper hinge and release the door
cable (3) and remove the cable
from the connector (4). Remove
the upper hinge (5), which is
held in place with two screws.
Carefully loosen the hinge from
the cable. The hinge is provided
with a slit through which the cable
is threaded in or out.
5
Lift the door off the drying
cabinet.
2
The picture shows
rehanging from right hung
to left hung
1
3
4
5
17
Advertisement
Table of Contents
