Advertisement
Available languages
Available languages
Bulb Replacement
Attention! Before touching
a bulb make sure that it is cold
enough.
1. Disconnect the equipment from the
power source.
2. Remove the grease trap filters or the
exhaust hood screen.
3. Replace the burnt lamp.
Lamp
Power (W)
28
Cap
Voltage (Vt)
E14
220-240
Dimensions (mm)
67 (luminous center height)
Code ILCOS D
HSGSB/C/UB-28-220-240-E14-67
4. Install the grease filters or the exhaust
hood screen.
5. If the illumination does not work, before
you address to a Technical Support
Center, check please if the bulbs are
connected correctly.
Failures
In case of questions about functioning or a
failure please feel free to contact the Technical
Support Center.
(The list of the Technical Support Centers is
for your reference)
Indicate please:
N°-E
FD
Insert the numbers in the indicated fields. The
numbers are given in the plate, that is located
inside of the tool, you can see it only after the
filters are removed.
9
Advertisement
