Replacing bulbs ... 6 INSTRUCTION MANUAL Additional information on products, accessories, replacement Produktinfo parts and services can be found at www.bosch-home.com and in the online shop www.bosch-eshop.com Please find the contact data of all countries in the enclosed customer service list.
In combination with an activated vapour extractor hood, room air is extracted from the kitchen and neighbouring rooms - a partial vacuum is produced if not enough fresh air is supplied. Toxic gases from the chimney or the extraction shaft are sucked backed into the living space.
Operating modes This appliance can be used in exhaust-air mode or circulating- air mode. Exhaust air mode The air which is drawn in is cleaned by the grease filters and conveyed to the exterior by a pipe system. Note: The exhaust air must not be conveyed into a functioning smoke or exhaust gas flue or into a shaft which is used to ventilate installation rooms which contain heating appliances.
Installing and removing filter ã= Risk of burns, risk of electric shock! from appliance. Always leave appliance to cool down before cleaning or servicing. Switch off fuse or pull out mains plug. Removing metal-mesh grease filter Open lock and fold down the metal-mesh grease filter. In doing so, place other hand under the metal-mesh grease filter.
Replacing bulbs ã= Risk of burns, risk of electric shock! from defective bulbs. Switch off fuse or pull out mains plug. Always replace defective bulbs immediately (leave bulbs to cool down first) to prevent the remaining bulbs from overloading. Important! Use only bulb of the same type and same power (see bulb holder or rating plate inside the appliance) –...
INSTALLATION INSTRUCTIONS Ins tallation in structio ns HOHFWUR PP Safety notes ã= Mortal danger, risk of intoxication! Due to combustion gases sucked back in. Never operate the appliance in the exhaust air mode at the same time as a room air-dependent heat-producing appliance unless an adequate supply of fresh air is ensured.
Installation Pipe dimensions Note: The device manufacturer does not assume any warranty for complaints attributable to the pipe section. The device achieves its optimum performance by means of a ■ short, straight exhaust air pipe and as large a pipe diameter as possible.
Connecting the pipes Note: If using an aluminium pipe, smooth the connection area beforehand. Exhaust-air pipe Ø 150 mm (recommended size) Attach exhaust-air pipe directly to the air-pipe connector and seal. Exhaust-air pipe Ø 120 mm Attach reducing connector directly to the air-pipe connector. Attach exhaust air pipe to the reducing connector.
Need help?
Do you have a question about the DWW07D650B Installation Instructions and is the answer not in the manual?
Questions and answers