Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Bosch DWW09W450B Installation Instructions
Summary of Contents for Bosch DWW09W450B Installation Instructions
- Page 1 Extractor hood [en] Instructions for installation and use...
-
Page 2: Table Of Contents
Attaching the flue duct............... 11 INSTRUCTION MANUAL Produk tinfo Additional information on products, accessories, replacement parts and services can be found at www.bosch-home.com and in the online shop www.bosch-eshop.com : Important safety information Read these instructions carefully. Only then Children must not play with the appliance. - Page 3 Risk of fire! Grease deposits in the grease filter may ■ catch fire. Clean the grease filter at least every 2 months. Never operate the appliance without the Room air-dependent heat-producing grease filter. appliances (e.g. gas, oil, wood or coal- operated heaters, continuous flow heaters Risk of fire! Grease deposits in the grease filter may...
-
Page 4: Environmental Protection
Risk of electric shock! Causes of damage A defective appliance may cause electric ■ Caution! shock. Never switch on a defective Risk of damage due to corrosion. Always switch on the appliance while cooking to avoid condensation. Condensate appliance. Unplug the appliance from the can produce corrosion damage. -
Page 5: Operating The Appliance
Operating the appliance Setting the fan These instructions apply to several appliance variants. It is possible that individual features are described which do not Switching on apply to your appliance. Press button 1, 2 or 3. Note: Switch on the extractor hood when you start cooking and Switching off switch it off again several minutes after you have finished cooking. -
Page 6: Trouble Shooting
Cleaning the metal mesh grease filters Removing metal mesh grease filter Open the lock and fold down the metal mesh grease filter. Risk of fire! While doing this, place the other hand under the metal mesh Grease deposits in the grease filter may catch fire. grease filter. -
Page 7: After-Sales Service
Replacing bulbs Replacing filament bulbs Lift the bulb cover slightly and push towards the outside of Risk of electric shock! the appliance. When changing the bulbs, the bulb socket contacts are live. Unscrew the bulb and replace it with a bulb of the same type. Before changing the bulb, unplug the appliance from the mains or switch off the circuit breaker in the fuse box. -
Page 8: Installation Instructions
INSTALLATION INSTRUCTIONS Ins tallation in structio ns PLQ PLQ PLQ This appliance is installed on the wall. ■ Follow the enclosed installation instructions for additional ■ special accessories (e.g. for circulating-air mode). The surfaces of the appliance are sensitive. Avoid damaging ■... -
Page 9: General Information
Safe operation is possible only when the Risk of fire! partial vacuum in the place where the heat- Grease deposits in the grease filter may producing appliance is installed does not catch fire. The specified safety distances exceed 4 Pa (0.04 mbar). This can be must be observed in order to prevent an achieved when the air needed for accumulation of heat. -
Page 10: Checking The Wall
Checking the wall Electrical connection The wall must be level, vertical and adequately load-bearing. ■ Risk of electric shock! The depth of the bore holes must be the same length as the ■ Components inside the appliance may have sharp edges. screws. -
Page 11: Installation
Installation Connecting the appliance to the power supply ¨ Attaching and aligning the appliance. Connecting the air extractor © Mark the hole for the safety screw. ª Note: If using an aluminium pipe, smooth the connection area beforehand. Remove the appliance once more. Attach the air extractor pipe directly to the air-pipe connector. - Page 12 Robert Bosch Hausgeräte GmbH Carl-Wery-Straße 34 81739 München Germany www.bosch-home.com *9000773608* 920712 9000773608...