Bosch DWW063461 Operating And Installation Manual page 13

Connection to the Power Source
The electric line voltage shall comply with
the voltage, indicated in the nameplate,
which you can find inside of the exhaust
hood. If the exhaust hood is supplied with a
plug, connect it to the connector assembly in
accordance with the valid regulations, the
connector assembly shall be located in an
easily accessible place.
If the plug is not provided (direct connection),
or the connector assembly is located in a
difficult accessible place
- use the appropriate two-pole switch that
provides a full disconnecting from the line in
case of overvoltage category III, according
to the installation instructions.
Attention: before connecting the
exhaust hood to the line and checking if
its functions properly make sure that the
power cable is connected correctly.
13