Advertisement
Quick Links
Table Of Contents
Introduction � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 1
Safety Requirements � � � � � � � � � � � � � � � � � � � � � � � � � � � � 1
Resources Required � � � � � � � � � � � � � � � � � � � � � � � � � � � � 2
Installation Instructions � � � � � � � � � � � � � � � � � � � � � � � � � 2
Securing Bikes � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 4
Patent protected, trademarked, and produced by Let's Go Aero, Inc.
Corporate Office: 4474 Barnes Road, Colorado Springs, CO 80917 USA.
Made in China.
US Patent Numbers: 8,899,456, D717,716, D717,717, D684,917, D722,289,
patents pending.
www.lippertcomponents.com
(574) 537-8900
Jack-It™
Aftermarket Manual
Jack-It™
Aftermarket
Manual
Introduction
The Jack-IT™ is a bicycle rack designed to attach to your RV.
Additional information about this product can be obtained from
www.lci1.com/support or by downloading the free myLCI app.
The app is available on iTunes® for iPhone® and iPad® and
also on Google Play™ for Android™ users.
iTunes, iPhone, and iPad are registered trademarks of Apple
Inc. Google Play and Android are trademarks of Google Inc.
Lippert Components, Inc. recommends that the following
inspections, troubleshooting, component replacement and
verifications be completed only by certified RV technicians.
Safety Requirements
Moving parts can pinch, crush or cut� Keep clear and
use caution�
Failure to follow the instructions provided in this
manual may result in death, serious injury, vehicle
damage or voiding of the component warranty�
The use of this product while bicycles are loaded may
affect the turning radius on some vehicles� Check the
turning radius before travel�
1
Rev: 02.17 - Jack-It™ Aftermarket Manual
Advertisement
Related Manuals for Lippert Components Jack-It
Summary of Contents for Lippert Components Jack-It
- Page 1 Aftermarket Manual Introduction The Jack-IT™ is a bicycle rack designed to attach to your RV. Additional information about this product can be obtained from www.lci1.com/support or by downloading the free myLCI app. The app is available on iTunes® for iPhone® and iPad® and also on Google Play™...
-
Page 2: Installation Instructions
3� Attach the base (Fig�1E) to stinger (Fig�1F) using the NoMotion pin and washers (Fig�1C, 1D and 1A). For safety, insert the cotter pin (Fig�1B) through the hole at the end of the NoMotion pin (Fig�1C) after tightening securely. Fig�1 www.lippertcomponents.com (574) 537-8900 Rev: 02.17 - Jack-It™ Aftermarket Manual... - Page 3 (Fig�2C). Attach 1 on each wing facing the tow vehicle and 1 on each wing facing the trailer. Note: Adjustment will be necessary depending on the size and desired position of the bicycles. www.lippertcomponents.com (574) 537-8900 Rev: 02.17 - Jack-It™ Aftermarket Manual...
- Page 4 Fig�3 Manual information may be distributed as a complete document only, unless Lippert Components provides explicit consent to distribute individual parts. Always make sure all connections between the bicycle rack and the trailer coupler are secure/tight/ready for All manual information is subject to change without notice.
Need help?
Do you have a question about the Jack-It and is the answer not in the manual?
Questions and answers