Table of Contents
Advertisement
IPG-UI Setup for TPS65291
•
Click the Create Project button.
NOTE: After a project is initially created, it is available in the Create Projects from Recent Devices
menu. When a project is saved, it is available in the Open Recent Projects menu.
•
Verify that a blue notification appears stating that register write access is enabled as shown in
Figure
19.
Figure 19. Successful Write Access to TPS65291 Notification
•
The TPS65291 Introduction tab is now displayed. If a red notification appears (as in
indicates the computer can talk to the USB2ANY but cannot communicate with the TPS65291 device.
The primary cause of this issue may be that the power supply is not turned on or a cable is unplugged.
In case of either issue, the test setup of the EVM must be debugged before continuing.
Figure 20. Failed GUI Communication to TPS65291 Notification
•
Click the Get Started button or the Register Map tab shown in
writing to registers to evaluate the TPS65291 device.
18
Software Installation and Setup Instructions
Figure 18. Creating New IPG-UI Project for the TPS65291
Copyright © 2017, Texas Instruments Incorporated
Figure
Figure 21
to begin reading from and
SLVUB61 – July 2017
Submit Documentation Feedback
www.ti.com
20), it
Advertisement
Table of Contents
