Key Words - Hamilton G10.211 General Instruction Manual

7.

Key Words

Screw-in crown
On certain models the crown
antee optimal water-resistance. It must be unscrewed
to make adjustments. After adjustments make sure it
is screwed in again.
Please note that water-resistance is only guaranteed
when the crown is screwed in.
Tachymeter or tachymiler
Scale showing the average speed of a vehicle. Using
the chronograph Start-Stop function, measure the
time taken to travel 1 km or 1 mile. The average speed
can be read on the tachymeter or tachymiler scale.
Example: 1 km or 1 mile traveled in 20 seconds =
180 km/h or 180 miles/h
EOL function
Indication of the end of battery life. If the seconds
hand starts to move in 4-second steps, the battery
should be changed.
Elapsed time on the exterior rotating bezel
Scale for measuring elapsed time.
1. Turn the bezel counterclockwise until the arrow
E
points to the minutes hand.
2. The minutes hand will indicate the elapsed time on
the graduated scale of the rotating bezel.
For further information, please visit the HAMILTON
University: www.hamilton-uni.com
GENERAL INSTRUCTION MANUAL | INTERNATIONAL WARRANTY
is screwed in to guar-
C
7