Programming Playback Using Main Unit Controls - Panasonic SL-PR300 Operating Instructions Manual

Listening to CDs
Programming Playback Using
Main Unit Controls
It is possible to select your own program (order of tracks being
played) using the program playback mode. Any of the tracks (1-99)
on the CDs in the trays of the 3-CD changer can be selected.
If you want to program and record tracks, see "Program Edit
Recording" on page 30.
COMPACT DISC RECORDER SL-PR300
POWER
PHONES
MIN MAX
PLAY MODE CD EDIT CD REC
2 7
1
Load CDs into the trays of the 3-CD changer.
• Only tracks on the CDs loaded in the 3-CD changer can be reg-
istered into the program.
Note
• To close a tray, press the 0 button for the tray number that is
open. If you press the 0 button for a tray number other than that
for the tray that is open, the program may not be played correctly.
2
Press the PLAY MODE button when the unit is
in the CD stop mode.
• The CD PLAYER indicator is shown in the display window,
PROGRAM indicator is shown in the display window, and if no
program has been registered, "PG NO PROGRAM" is shown in
the information display.
Program step
number
3
Press the SET button to start program
registration.
• The information display will show the following, and disc
source columns will flash.
Programming
step number
RQT6087
1
OPEN / DISC
CLOSE SELECTOR OPEN /
3 CLOSE
3
DISC
2
DISC 2
DIGITAL CD LINE REC SELECTOR
1
DISC
1
SYNCHRO MENU SET CANCEL
REC/
FINALIZE REC MUTE
3,4,5
Disc source
Track number
Disc source
Track number
4
Select the disc source (CD tray) by turning the
MULTI JOG control, and then press the SET but-
ton.
1. Select the disc.
CD1
4,5
• When the SET button is pressed, next the programming step and
MULTI JOG
track number columns will flash.
REC LEVEL
– +
MIX BALANCE
5
LINE CD
Select and enter a track number (1-99) by
turning the MULTI JOG control, and then press
the SET button.
1. Select the track.
• The following is an example of track 2 on the CD in tray DISC1
being entered as Step 01.
• When the SET button is pressed, the programming of Step 01 is
registered, and programming for Step 02 is ready.
6
Repeat steps 4 and 5 to program up to a
maximum of 32 steps.
• If you try to program over 32 steps, "MEMORY FULL" is
shown in the information display, and the programming func-
tion ends automatically.
• Pressing the CD Control STOP s button on the main unit ends
the programming function.
MULTI JOG
REC LEVEL
–
+
2. Enter the selection.
CD2 CD3
MULTI JOG
REC LEVEL
–
+
2. Enter the selection.
SET
SET