Calling Up The Display Information; Setting The Clock - Renkforce AN-8006 Operating Instructions Manual

Calling up the display information

You can call up different information via the display (3) with the button 9 / DISP (9) depending on the operating mode.
Each push of a button switches the called up information further. After 5 seconds, the display automatically returns
to the basic display (first display in the list below).
When an RDS station is being received
Radio operation:
CD/USB/SD operation:
When no RDS station is being received
Radio operation:
CD/USB/SD operation:

If the transmitter does not transfer any time information or PTY information, the display shows NO
CLOCK or NO PTY.

Setting the clock

When receiving an RDS station with time transmission, the clock of the CD tuner automatically jumps to the right time.
However, the time can also be set manually.
• Press the button 9 / DISP (9) approx. 5 seconds until the time blinks on the display (3).
• Turn the volume control/dial control (23) clockwise to set the hours.
• Turn the volume control/dial control (23) counter-clockwise to set the minutes.
• This setting is applied automatically when the display returns to the basic setting.

As soon as an RDS transmitter is received with time transmission, the manually set time is overwritten
with the RDS time.
68
Station name > received frequency > time > program type
CD/USB/SD information > station name > received frequency > time > program type
Received frequency > time > NO PTY
CD/USB/SD information > received frequency > time > NO PTY
Operating Instructions

English