Removing And Replacing The Front Control Panel - Renkforce AN-8006 Operating Instructions Manual

Removing and Replacing the Front Control Panel

The front control panel can be removed to prevent theft.
• Before you remove the front control panel, press and hold the POWER/
MUTE button (1) to turn the product off.
• Press the button OPEN (5) to fold down the front operating panel.
• Hold the front panel on the right side, carefully press it to the left to unlatch
it and then pull it out of its attachment.
• When you remove the front control panel, please put it into the supplied
protective cover.
• To attach the operating panel, place the left side in the mount as shown
on the illustration below and carefully press it to the left until the right side
snaps into the mount as well.
• Fold up the control panel again until the latch snaps into place.
• Do not press on the display or the buttons.

Make sure that you place the front operating panel correctly on
the device and that it snaps flush into the mount.
Do not press the front control panel too strongly against the
device. You can easily put it back by pressing slightly on the
device.
54
Operating Instructions

English
1
2