Compool Cp3600 Installation & Operating Instructions Manual page 41

Compool Cp3600
Heat Source does not allow Solar
Solar heating stops too soon
Spa-side Remote does not operate
No display at Control Panel
Clock lost time after power failure
System not responding
Determining revision date
At the Power Center circuit board, the SPEC FNCT configuration switch SOLR needs to
be turned on. See Configuration Switches for details.
Verify solar temperature is calibrated correctly. See Calibration for details.
At the Control Panel, verify Remote Control at Spa lamp (behind right-side door), is
turned on.
Check circuit breakers in the Sub-panel and Power Center.
Check communication cable.
Replace battery located on Power Center circuit board.
Reset the Control Panel. Locate small hole next to the Pool Temperature keys. With a
pointed object, push the reset button.
Reset the Power Center. Locate small hole next to Auto/Service key. With a pointed
object, push the reset button.
At the Control Panel, press and hold the Enter key. The numbers on the left indicate the
Control Panel revision number, the numbers on the right indicate the Power Center
revision number.
39