Programming A Once-Only; Canceling Programs; Setting The Time Of Day; Remote Control At Spa Key - Compool Cp3600 Installation & Operating Instructions Manual

30
Follow Programming example, set START TIME to 0:00 hours. Set RUN TIME to the number
of Hour/Minutes before equipment should Time-out.
Note If the RUN TIME is set for 24 hours, manually activated equipment will run continuously
until manually turned off.

Programming a Once-only

The Once-only program is used to start the spa after a few hours, for example, you would like
to have the spa start in 2 hours. Once the program executes, it is automatically erased.
Follow the programming example above, enter the time the Spa should start (START TIME)
and set the RUN TIME to 0:00.

Canceling Programs

• To cancel all of the programs
1.
2.
3.
• To cancel an individual program
1.

Setting the Time of Day

To set the TIME OF DAY, press the Hours/Minutes key to set correct time. Pay attention to the
AM/PM symbol.

Remote Control at Spa key

It is possible to disable the Spa-side Remote from your Control Panel by pressing the Remote
Control at Spa key. The key is located behind the right-side door of the Control Panel. If the
status lamp is on, the Spa-side Remote is operational. If the status lamp is off, the Spa-side
Remote is disabled.
Press the Program key. The Display will show a row of blinking icons located
immediately above the eight Equipment keys.
Press and hold down the Cancel key for 5 seconds. After 5 seconds, a continuous alarm
will sound (until you release the Cancel key), indicating that all of the programs have been
erased.
Press the Program key to end.
When programming or reviewing a program, pressing the Cancel key will return the
START TIME and RUN TIME to "0:00".
Compool Cp3600