Wireless Router + Modem; Configure On Laptop / Pc - Avtech AVM302A Network Setup Manual

Note: Check (LAN) status indicator is always on, not blinking. If it's blinking, check your RJ45
network cable and ensure it's not disconnected or defect.
If you're using:
 Wireless router + modem, please refer to "1.3 Wireless Router + Modem".
Router + modem, please refer to "1.4 Router + Modem".

 Modem or modem + hub, please refer to "1.5 Modem / Hub + Modem".
For your account safety, it's recommended to change the default account setting. For details, please refer to "1.6
Change Default Account" at page 14.

1.3 Wireless Router + Modem

You may use your laptop / PC, or your iPhone / iPad to complete the network configuration of the camera.

1.3.1 Configure on Laptop / PC

Before configuring this camera on your laptop / PC, make sure:
 Your Windows operating system is Windows 7, Vista or XP.
 (Recommended) Your wireless router supports UPnP, and this function is enabled.
Note: If your wireless router doesn't support UPnP, you need to additionally access your router for port
forwarding. For details, please refer to "APPENDIX 4 CONFIGURE PORT FORWARDING" at page
22.
 You have noted down the IP address of your router, and the assigned IP address(es) and port(s) of other
devices connected to the same router.
Note: For details, please refer to the user manual of your wireless router, or check with your installer.
 You have downloaded "IPScan.exe" in your laptop / PC.
Note: Please download "IPScan.exe" from www.surveillance-download.com/user/m317a.swf.
Step1: Connect your laptop / PC to the wireless network with the camera connected.
Laptop or PC
with
P Scan Tool
program
Devices connected with a RJ45 network cable
Devices connected wirelessly
Step2: Open "IPScan.exe" ( ) to search your camera, and:
 Note down the IP address and port number after search, such as "192.168.2.25" and "88" in our example.
 Select the IP address, and click "Configure" to note down the gateway IP address. It's the address of your wireless router,
and you might need it later for port forwarding.
 Change the port you're using for this camera to other value (such as "8080") in "Web Port" if you know the default port
number "88" is blocked by your Internet service provider or phone carrier. Then, enter the user name (admin) and
password (admin) to confirm.
The number of "80" is not recommended to use since some Internet service providers and phone carriers might block the
use of "80".
LAN Port WAN Port
Wireless
Router
Modem
6