Table of Contents
Advertisement
44
www.aeg.com
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display does not show
the time during the off sta-
tus.
The core temperature sensor
does not operate.
It takes too long to cook the
dishes or they cook too
quickly.
Steam and condensation
settle on the food and in the
cavity of the oven.
The display shows "C2".
The display shows an error
code that is not in this table.
The descaling procedure is
interrupted before it finishes.
Possible cause
The necessary settings are
not set.
The automatic switch-off is
activated.
The Child Lock is on.
The fuse is blown.
The lamp is defective.
The display is deactivated.
The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et.
The temperature is too low
or too high.
You left the dish in the oven
for too long.
You want to start the Defrost
function, but you did not re-
move the core temperature
sensor plug from the socket.
There is an electrical fault.
There was a power cut.
Remedy
Make sure that the settings
are correct.
Refer to "Automatic switch-
off".
Refer to "Using the Child
Lock".
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Replace the lamp.
Touch
and
at the
same time to activate the
display again.
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
Adjust the temperature if
necessary. Follow the advice
in the user manual.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Remove the core tempera-
ture sensor plug from the
socket.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
Repeat the procedure.
Advertisement
Table of Contents
