General Operation - Axis AT1912KIT Manual

GENERAL OPERATION

Turn on/off the unit
Press the /SRC button to turn on the unit. When the unit is on. Press and hold it for 2
seconds to turn off the unit.
Sound and setting adjustment
Shortly press the SEL button to open the audio menu:
BASS ->TRE (Treble) ->BAL (Left or Right Speaker Balance) ->FAD (Front or Rear Speaker
Fader) ->EQ(class/rock/pop/flat/off) ->LOUD(on/off)
Press and hold the SEL button to open the settings menu:
BEEP(on/off) ->CLOCK(12/24) ->P_VOL(Power on Volume Level) ->CT(indep /sync)
->AREA(AUS/USA) ->DX/LOC (Distant or Local Reception)->STEREO/MONO
In each item press VOL+/- button to set them.
BEEP (ON/OFF): Turn on/off the beep tone when pressing buttons.
CLOCK (12/24)
Press VOL+/- to choose 12 hours format or 24 hours format for the clock.
P_VOL (Preset-volume)
Setting the power on volume. When the unit is turned off, if the volume is greater than the
P-VOL setting, the volume will be restored to the P-VOL value the next time the unit is
turned on.
CT(indep/sync)
CT indep: The clock works independently. It wont be synchronized to the radio
station's time.
CT sync: When tuned to a RDS station, the clock will be synchronized to the radio station's
time. Note: When the time is set manually, the CT will revert back to INDEP
mode automatically.
AREA (AUS/USA)
Press VOL+/- to choose either Australia or USA radio region.
Clock setting
Press and hold the DISP button for 2 seconds. The "HH" will flash. Press the VOL+/- button
to change the hour. After that press the DISP (or SEL) button, the "MM" will flash. Press the
VOL+/- button to change the minute. Then press the DISP (or SEL) button to confirm.
Reset the unit
a) In AUX mode press and hold the ">II" button for 5 seconds to reset the unit.
Note: if the RESET function is activated, all the settings will be lost.
5