Luggage Cover; Refit - MG RX8 Manual

*

Luggage Cover

When you do not need to use a luggage cover or when
you need to place a large luggage in the rear loadspace, the
luggage cover can be retracted and stored in the storage
compartment.
Note: Error-proofing marks such as "L", "R" and
triangular arrow etc. are provided on both sides of
the luggage cover to facilitate the identification of the
connection between the end cap and the end surface
of luggage cover.

Refit

1 Compress the right end of the luggage cover first
and then lift up to remove it from the storage
compartment.
2 Then remove the two end caps of the luggage cover
from both sides of the storage compartment.
72
Instruments and Controls
3 The two end caps can be interfaced with both sides of
the luggage cover respectively as illustrated below: fit
A1 and A2 of the end cap with the B1 and B2 grooves
at the end of luggage cover with a certain angle, then
turn it along the direction of CLOSE to lock it.
Note: When the end cap is locked, you can hear
the 'Click' sound, it indicates that the end caps
are assembled and the two planes are parallel and
level.