Right Weigh 201-EBT-01B Installation, Calibration, And Maintenance Log

INSTALLATION, CALIBRATION,
AND MAINTENANCE LOG
FOR 201-EBT-01B, 201-EBT-02B, & 201-EBT-04B
MSU ID:
Hardware #: RWLS-0-42-2(SKU-A)
Firmware #: 42.008
The 201-EBT-01B, 201-EBT-02B, and 201-EBT-04B Load Scales are TCA (Transportation Certification
Australia) Category A Type-Approved On-Board Mass (OBM) Systems. This organization approves
automotive technology that follows a set of guidelines to ensure consumer safety and device reliability. For
more information visit their website at:
https://tca.gov.au/publication/obm-system-specification/
Please follow the load scale instructions in the Installation & Operation Manual to correctly install and
calibrate the MSUs (Mass Sensor Units). To comply with TCA Category A Type-Approved Requirements, the
following pages must be used to record the installation and all calibration and maintenance events. This
document must be kept with the vehicle at all times.
DOCUMENT REVISION LOG
REVISION DATE
A 5/19/2020
B 7/20/2020
C 7/29/2020
D 9/22/2020
E 10/16/2020
CONTACT US!
Smart Truck Solutions
+61 418 622840
rightweigh.com.au
PAGE
Preliminary Release
Re-calibrate every 6 months, remove BT logo from gauge sticker, update firmware
1, 2
# to 42.008, add revision log.
Removed calibration, created specific maintenance steps to check, added gauge
1, 2
ID and truck VIN # separately.
2
Made document 2 pages instead of 3.
ALL C ombined the Installation, Calibration, and Maintenance Logs into one document
SUMMARY
PP-003-0065 REV E
AUTHORIZED BY
H. Gooding
H. Gooding
H. Gooding
H. Gooding
H. Gooding
Follow Us!
Follow Us!