Device And Operator Actions For Equipment Errors - Fujitsu M4099D Reference Manual

Device and Operator Actions for Equipment Errors

If an equipment error is detected in the scanner, the (CHECK) lamp at the operator panel blinks.
Lamp Alarm: Front
Lamp Alarm: Back
Optical error: Front
Optical error: Back
Hopper over run
Paper feed error.
Clear paper path to continue
Hardware alarm
EEPROM alarm
Heater Alarm 1
Heater Alarm 2
5-14
Check if the lamp is attached correctly. Replace lamp
according to the replacement method. If turning the power on
again does not recover a scanner, contact a manufacturer's
authorized service center.
Make sure that there is not anything on the hopper table or in
the transport path. If turning the power on again does not
recover a scanner, contact a manufacturer's authorized
service center.
If turning the power on again does not recover the scanner,
contact a manufacturer's authorized service center.