GMI SR-7000 Manual

TOOLS REQUIRED FOR ASSEMBLY

Socket set, Open end wrench set, Cordless
drill with 3/8" socket bit (Magnetic recommended).

BEFORE ASSEMBLY

Read through the assembly instructions to
familiarize yourself with the order in which
the parts are assembled. We suggest that
you clear & vacuum the area where the bench
is to be assembled. It is important that the
bench is assembled in the same sequence
as instructed.

HARDWARE

All assembly hardware is provided.
Attach the low profile top modesty panels to
the main top and the arched side table top.
Use (2) 5/16 x 1-1/2" hex head bolts, flat
washers and lock washers per panel.
Bolt from the bottom of the top through
the pre-drilled holes in the top and into the
pre-installed nuts in the bottom of the panel.
Attach the main top to the cabinet. Center the
top front-to-back and side-to-side. From inside
the cabinet attach the top using (10) #10 x 5/8"
Spax wood screws in the holes around the
perimeter of the cabinet and into the bottom of
the top.
Attach the side tables back modesty panel to the
side of the leg. Position the modesty panel
so the notch on the top of the modesty
panel is at the top of the leg so you can
access the top mounting holes of the leg.
Use (2) 1/4-20 x 1/2" flange head bolts to
mount the modesty panel to the pre-
installed nuts on the leg.
1/4-20 x 1/2"
Flange Head Bolt
5/16 Flat Washer
5/16 Lock Washer
5/16-18 x 1-1/2"
Hex Head Bolt
#10 x 5/8"
SPAX Wood Screw
SR-7000
Notched side toward leg.