GMI AC-INS Assembly Instructions

TOOLS REQUIRED FOR ASSEMBLY

Electric Hand Drill, 3/8" Magnetic Socket Bit.

Read through the assembly instructions to familiarize yourself with the order in which the parts are assembled.

We suggest that you clear & vacuum the area where the bench is to be assembled.

It is important that the bench is assembled in the same sequence as instructed.

All assembly hardware is provided.

Carefully place work surface upside down

on the floor. **Be sure floor is clear of any

debris that may scratch the top**

Set threaded inserts into all .375" holes. Use

hex driver bit provided. When inserted

properly, the flange will set flat & flush with the

work surface. (You will need to use the torque

setting on your drill.)

Connect the 2 tops together exactly

as shown to the right. Use #14 x 1" Lag

Screws.

Set the legs on the work surface as shown to

the right. Finger tighten bolts.

Standard Legs - Use 1/4 x 1-1/2" Bolts.

Corner Ped - Use 1/4 x 1/2" Bolts

AC-INS ASSEMBLY INSTRUCTIONS

Table of Contents

Do you have a question about the AC-INS and is the answer not in the manual?

Page 1 AC-INS ASSEMBLY INSTRUCTIONS TOOLS REQUIRED FOR ASSEMBLY Electric Hand Drill, 3/8" Magnetic Socket Bit. BEFORE ASSEMBLING THE WORKBENCH Read through the assembly instructions to familiarize yourself with the order in which the parts are assembled. We suggest that you clear & vacuum the area where the bench is to be assembled.
Page 2 Attach modesty panel to the legs with 1/4-20 x 1/2" Flange Head Bolts. Finger tighten. Starting with the bolts connecting the legs to the top, Fully tighten all bolts. Insert velcro wire holds into the wire tray as shown to the right.