GMI PC-3000-200 Assembly Instructions

Table of Contents

Download this manual

TOOLS REQUIRED FOR ASSEMBLY

Electric Hand Drill, Phillips Head Bit, 3/8" Magnetic

Hex Driver Bit.

Read through the assembly instructions to familiarize

yourself with the order in which the parts are

assembled.

We suggest that you clear & vacuum the area where

the bench is to be assembled.

It is important that the bench is assembled in the same

sequence as instructed.

All assembly hardware is provided. Full size photos

accompany each step where hardware is needed.

Drafting Top

Left Leg

Modesty Panel

Rear Brace

Pencil Edge

PC-3000-200 ASSEMBLY INSTRUCTIONS

Keyboard Bracket

Front Brace

(with hinge)

Reference Top

Right Leg

CPU Cabinet

Table of Contents

Do you have a question about the PC-3000-200 and is the answer not in the manual?

Page 1 PC-3000-200 ASSEMBLY INSTRUCTIONS TOOLS REQUIRED FOR ASSEMBLY Electric Hand Drill, Phillips Head Bit, 3/8" Magnetic Hex Driver Bit. BEFORE ASSEMBLING THE WORKBENCH Read through the assembly instructions to familiarize yourself with the order in which the parts are assembled. We suggest that you clear & vacuum the area where the bench is to be assembled.
Page 2 Lay RIGHT leg on the floor (see part identification on p.1). Attach the front brace, rear brace & modesty panel to the leg. Braces must be oriented as shown below. Use two 1/4-20 x 1/2" Flange Head Bolts for the modesty panel & two 1/4-20 x 1/2" Flange Head Bolts for each brace.
Page 3 Turn the base onto the tops. Attach the LEFT leg to the braces & modesty panel. Use 1/4-20 x 1/2" flange head bolts Line up the front brace holes with the holes in the reference top. Secure with four 1/4-20 x 1/2"...
Page 4 Tip the station back onto its fight side. Fasten the CPU cabinet (or CPU rack) to the right leg using four 1/4-20 x 1/2" flange head bolts. Turn table back into the upright position. Secure the monitor arm to the back right-hand corner of the station. Place grommet into large hole on reference top.