GMI B Series Assembly Instructions

TOOLS REQUIRED FOR ASSEMBLY

Socket set, Open end wrench set, Cordless
drill with 3/8" socket bit (Magnetic recommended).

BEFORE ASSEMBLY

Read through the assembly instructions to
familiarize yourself with the order in which
the parts are assembled. We suggest that
you clear & vacuum the area where the bench
is to be assembled. It is important that the
bench is assembled in the same sequence
as instructed.

HARDWARE

All assembly hardware is provided.

LEVELER KIT OPTION

**SKIP THIS STEP IF YOU HAVE NOT PURCHASED THE LEVELER OPTION**
Thread 1 thin nut onto the leveler.
Place leveler into floor-mount hole at
the base of the leg. Thread a second
thin nut onto the leveler.
Loosen & tighten nuts to adjust the height
of your work bench.

MOBILE CASTER KIT OPTION

**SKIP THIS STEP IF YOU HAVE NOT PURCHASED THE CASTER OPTION**
Attach the single bolt casters to the bottom of the legs or the base of the insert if
its an adjustable height bench..
NOTE: TWO TYPES OF CASTERS ARE PROVIDED (SWIVEL AND FIXED) BE SURE TO USE
TWO OF THE SAME TYPE AT EACH END OF THE BENCH (TWO SWIVEL CASTERS ON
THE RIGHT AND TWO FIXED ON THE LEFT). ALSO BE SURE THE FIXED CASTERS ARE
POSITIONED SO THE GREASE ZERK IS ACCESSIBLE FROM THE OUTSIDE OF THE
BENCH (SEE FIG. 2). IF ALL SWIVEL CASTERS ARE ORDERED, PLACEMENT WILL NOT
BE IMPORTANT.
Insert the top of the caster into the angled lip pocket (this will be the side opposite
of the bolt holes), tilt the caster flat against the mounting plate until the bolt is
able to be slid behind the caster, locking it in place. Bolt in place using (1) 3/8" x
4-3/4" long hex head bolt and 3/8" nylock nut. Repeat steps for the other caster
locations.
Nylock Nut
3/8" x 4-3/4"
Flange Head Bolt
B SERIES POTTING BENCH