Connecting The Keyboard; Connecting The Mouse; Connecting Devices With Serial Or Parallel Port - Fujitsu Siemens SCENIC 600 Operating Manual

Preparation for use and operation

Connecting the keyboard

Use only the keyboard cable supplied.
i


Plug the round plug of the keyboard cable into the keyboard port on the system unit.

Connecting the mouse

Plug the connector of the mouse cable into the mouse port.
If you do not attach a mouse at the PS/2 mouse port, you can disable the mouse
i
controller in the BIOS-Setup in order to free the IRQ12 for a different application.

Connecting devices with serial or parallel port

Connect the data cable to the external device.


Connect the data cable of the external device to the appropriate port on the system unit.
Most devices that you connect to the serial or parallel port require special drivers. Your
i
operating system already includes many drivers . But if the driver you need is not on the
hard disk please install it from the floppy disk supplied with the device or with the
application program.
If you need to change the default settings of the serial or parallel port (e.g. address,
interrupt), you can do so in the BIOS Setup. The default setting for the interfaces are
described in the Technical Manual for the system board or in the "BIOS Setup" manual.
12


Plug the other connector of the keyboard
cable into the socket on the underside of
the keyboard.
Connecting devices
A26361-K520-Z100-4-7619