Changing The Floppy Disk Drive - Fujitsu Siemens SCENIC 600 Operating Manual

Changing the floppy disk drive

Open the system unit (see


Remove the hard disk carrier (see
If necessary, you must adapt the entry for the drive in the Setup menu.
i
A26361-K520-Z100-4-7619
"Opening the system
"Installing and removing the hard disk
1
2
2
1
unit").


Pull the data and the power supply
connectors from the floppy disk drive.


Remove the screw (1) and take the drive
out of the system unit (2).


Take the new floppy disk drive out of its
packaging.


Push the drive into the system unit (1), and
fix it with the screw (2).


Plug the data and the power supply
connectors into the floppy disk drive.


Remove the hard disk carrier (see
"Installing and removing the hard disk
drive").


Close the system unit (see
the system unit").
System expansions
drive").
"Assembling
37