Outline Drawings; Noise And Vibration; Checks To Pump Delivery, Storage; Shipping And Handling - M Pumps CN SEAL-MV Series User Manual

8.

OUTLINE DRAWINGS

Please refer to specific documentation, supplied with the present manual.
9.

NOISE AND VIBRATION

The pump noise depends primarily on the operating conditions. The operating condition of the pump during the
measurements is: the coupling of the pump with the electric motor on the bench with pumping fluids.
The A-weighted sound pressure level to front and side of the pump is below 85 dB (A).
When pump noise level exceeds 85 dBA attention must be given to prevailing Health ans Safety legislation, to
limit the exposure of operating personnel to the noise. An enclosure can be adopted to reduce emitted sound.
10.

CHECKS TO PUMP DELIVERY, STORAGE

All M PUMPS PROCESS pumps are tested before shipment and carefully packed for transport: at the reception
of the pump make sure that the pump has not been damaged during the transport. If there are problems, contact
immediately the carrier and inform M PUMPS PROCESS about what happened.
So that the pump is preserved over time as best as possible, we recommend storing it away from the sun, bad
weather and dust, if not immediately installed or used for long periods.
Stoppers closing the input and output connections of the fluid must not be removed until installation. If provided
with electric motor, observe also the motor manufacturer's storage formality.
The maximum allowable temperature range during storage, preservation and use must be between -15 e +40°C
with humidity between 10 e 90%.
11.

SHIPPING AND HANDLING

You should carry out a precautionary check of the pump at the receiving to detect and report any damage in the
transport and handling operations. In case of breakages contact immediately M PUMPS PROCESS.
The precautions to ensure the stability of the pump concern the possible slips and overturning caused by
handling and transport, which must be prevented by setting the pump casing of the pump with ropes to the
vehicle frame.
Pump and motor assembly cannot be moved manually due to its high weight.
To move a pump positioned on a pallet, enlarge as maximum as possible the forks and then operate.
For a stable lifting the pump can be lift as indicated in the figures:
12.

LIFTING

For a stable lifting the pump can be lift as indicated in the figures:
Bare frame pump without motor
Centre of gravity approximately in the middle
Pag. 14/49
Centre of gravity approximately in the middle
Doc. ISM0076_MANUALE_CN SEAL-MV_ENG_REV04.DOCX
Bare frame pump with motor